Dash Z Racing Blog
DashZRacing Phone Number 8776414829

This is a DIY installation guide for the 2010 and up Ford Mustang Halo Projector Headlights.  You can find these headlights at Dashzracing storefront.  If you still didn’t get them today, please check out the following and see how incredible these projector headlights are:

2010-2011 Ford Mustang CCFL Halo LED Projector Headlights – Chrome

2010-2011 Ford Mustang CCFL Halo LED Projector Headlights – Black

10-11 Ford Mustang LED Halo Projector Headlights – Chrome

10-11 Ford Mustang LED Halo Projector Headlights – Black

Before we start, please prepare the following tools in order to install these projector headlights smoothly:

Remove 4 7mm Bolts under the hood as the red arrows shown:

Remove 2 7mm bolts behind the fender rail

Remove 2 8mm bolts and 4 plastic clips as shown by the red and yellow arrows

Pull on side of the front bumper, then unplug the bumper light

Now you can remove the front bumper

Remove the temp sensor from the bracket on the front bumper

Then remove 4 plastic clips as shown by the yellow arrows

Now you can remove the plastic radiator shield

Remove 2 10mm bolts under the headlights

Remove the plastic clip and the 10mm bolts

Remove the headlight slight and remove the driving light bulb and unplug the harness

Now we can set up the wiring of the Halo on the new headlights, for more info, you can checkout the following article:

Led & Halo Projector Headlight Installation DIY Wiring

Now you can plug in the driving light and headlight harness into the new headlights

Replace plastic clip and tighten the 10mm bolt

Tighten 2 10mm bolts under the headlights

Replace temp sensor on mounting bracket

Replace the front bumper

Plug back in the bumper light

Replace plastic radiator cover and secure with 4 plastic clips

Replace 4 plastic clips and tighten 2 10mm bolts

Tighten 2 7mm screws

Tighten 4 7mm screws

Test all the lights before go on the street

The installation is now completed


Popularity: 4% [?]

Comments are closed.