Dash Z Racing Blog
DashZRacing Phone Number 8776414829

03-07 Infiniti G35 Halo LED Projector Headlights Installation Guide

Posted by dashzracing On November - 25 - 2010

This is a step by step installation guide for 2003-2007 Infiniti G35 Coupe Halo LED Projector Headlights.  These projector headlights feature with the Halo Ring, LED city lights and projector lens for the low beam.  These projector headlights are made for 2003, 2004, 2005, 2006 and 2007 Infiniti G35 Coupe (2 door) that comes with stock HID Kit.  Dashzracing has chrome housing, black housing and smoke housing available at dashzracing.com.  Now let’s get to work on the installation:

03-07 Infiniti G35 Halo LED Projector Headlights – Chrome 03-07 Infiniti G35 Halo LED Projector Headlights – Black

03-07 Infiniti G35 Coupe Halo LED Projector Headlights – Smoke

Step 1: The Infiniti G35 Halo LED Projector Headlights uses the OEM HID lihgts, te ballast is located below the headlights.

The box also comes with two ground wires for each headlight.

Step 2: Open the hood of your vehicle, on top of the bumper, there are 6 clips need to be removed.

Step 3: Behind the firewall, there are two screws holding the bumper, use a Phillip screwdriver or a 10mm socket to remove them.

Step 4: There are 10 Screws on the bottom of the bumper that need to be removed also, after 10 screws are removed, you can remove the bumper

Step 5: After the bumper is removed, you can remove the 4 screws that holding the headlights

Step 6: You can now remove the headlight slightly and unplug the socket from the housing

Step 7: Now you can transfer the HID from your OEM headlight to the G35 Halo LED Projector Headlights

Step 8: Remove the ballast from bottom using a Phillip screwdriver, there are 3 screws need to be removed

Step 9: Once you remove the screw, unplug the wires then open ballast slowly, behind it there is another plug and screw need to be removed.

Step 10: After the ballast is removed, we can put them aside and now remove the headlight bulb from the factory headlight

Step 11: Remove the socket wires completely from te headlight, then remove the bulbs carefully

Step 12: Now you can tranfer the bulbs to the new projector headlights

Step 13: After you install the light bulb, you can slide the HID socket wires inside the housing until it reachs the bottom

Step 14: Then you can plug the socket wires to the ballast

Step 15: Before screwing the ballast to the projector headlights, make sure to add the ground wire located where the finger pointed at

Step 16: After the ground wires is added, please make sure to put the cover back on correctly to prevent condensation

Connect the Wire that connects to the ballast

Step 17: The red (Power) and black (Ground) wires are for halo rings, which is optional to wire them on your vehicle.

Step 18: The other end of the ground wire will screw on the other end of the socket when install the headlights to the G35

Step 19: Connect the socket back on before putting te headlights on/ Screw them in place

Step 20: On the bottom, where the ground wire is sticking out, screw the ground onto the headlight as shown in the picture

Step 21: Check all the light before go on the street and after that the installation is completed

Step 5: After the bumper is removed, you can remove the 4 screws that holding the headlights

Popularity: 7% [?]

Comments are closed.