Dash Z Racing Blog
DashZRacing Phone Number 8776414829

This is an Installation Guide with pictures for the 99-05 Volkswagen Golf LED Strip Projector Headlights  (R8 Style), you can find a lot of different style of Golf Projector Headlights 99-05 in Dashzracing Storefront.  These VW Golf Projectr Headlights feature with Projector Lens for low beam, Halo Rings and the trendy LED R8 Style Strip.  Now, let’s check out the following gallery for Dashzracing collection:

99-05 VW Golf LED Strip Projector Headlights – Black (R8 Style)

99-05 VW Golf LED Strip Projector Headlights – Chrome (R8 Style)

99-05 VW Golf Halo LED Projector Headlights – Black

99-05 VW Golf Halo LED Projector Headlights – Chrome

99-04 VW Golf Halo Projector Headlights – Black

99-04 VW Golf Halo Projector Headlights – Chrome

99-04 VW Golf LED Strip Projector Headlights – Black (R8 Style)

99-04 VW Golf LED Strip Projector Headlights – Chrome (R8 Style)

Hardware needed:
1 x Handy Remover
1 x Trim Pad Remover
1 x Flat Tip Screw Driver
1/4″ Drive Ratchet
1/4″ Drive Extensions ( 6-10 in )
7mm Socket
10mm Socket

1. Open the hood

2. Loose the locking clip of the front grille

3. Detached the hood latch as the picture shown

4. Then we can remove the grille

5. Now we can remove the two screws as the red arrow indicated

6. Under the fender, there are screws that we need to remove

7. Then we need to remove the plastic piece on the lower of the bumper

8. There will be a screw that need to removed on the left upper corner

9. After the screw is removed, we can gently pull the bumper away from the car for now

10. Then we can remove the plastic shielding on the top

11. Then we can remove the two screws on top of the headlights

12. There are two screws also need to remove under the headlights as the picture shown

13. Now we can remove the headlights slightly then we can unplug the sockets on the back

14. Check out the Halo LED Instruction video about how to wire the Halo and LED

Led & Halo Projector Headlight Installation DIY Wiring

15. Plug the harness of the new headlights to the harness of the vehicle

16. Then we can put back all the screws back to the orginal place

17. And we can put back the bumper and put the the screws that has been removed

18. The plastic piece can also put back to its original place

19. Put back the hood latch that we took off and put back the clip

20. At last put back the front grille and the installation is completed

21. Please check all the lights before go on the road

Popularity: 4% [?]

Comments are closed.